Description.
Here is the circuit diagram of a simple 24W mono amplifier using IC TDA1516.The TDA1516 is an integrated class B power amplifier in a 13 pin SIL package. The IC has many useful features such as short circuit protection, load dump protection, thermal protection, reverse polarity protection etc. Here the IC is wired in BTL mode to deliver 24W of power into a 4 ohm speaker. This amplifier can be operated from a 12V DC supply and this makes it suitable for car audio applications.
Circuit diagram with Parts list.
Notes.
- Assemble the circuit on a good quality PCB.
- The amplifier can be powered using a 12V DC supply.
- Capacitor C2 must be rated at least 25V.
- The IC must be fitted with a heat sink.
- Switch S1 is the stand by switch.
18 Comments
If I want to make power supply of 12V for powering this circuit…
then what should be the current rating of transformer….?
or else provide the power supply circuit
Take two mobile charger in series
How can we use bootstrap in this circuit plz reply soon
Can we use TDA1518 and can u give me difference b/w both in terms of gain
Gain difference is about 20dB
Kiran Patil contact Vega Kits Mumbai. It is around Rs250/-
hi!!!!!!!!!
can you please tell me what is the cost of tda1516bq ic in india i mean in indian rupee.
thanks!!!!!
100
veri nice amp 2x12w or btl 1x24w btl no resistors simply datashet 🙂
Have u tried bootstrap circuitry
4 A
i just want to ask what is the current load requirement for the input?
0.42A at f=100hz
WHAT CURRENT IS NEED FOR THIS AMPLIFIER? 3 AMPERS?
~0.99A
Sir, if possible please give me full details regarding single transistor electronic ballast for florescent tubes powered by 230 vac 40 watts.Thank you very much.