LED Emergency Light
We have developed three circuits under Automatic LED Emergency Light. Two of them are designed by Mr. Seetharaman, a very valuable and important contributor of this website. We have listed the circuits here for your ease of reading. If you have any doubts; please comment with circuit name or circuit number.
This is one of the most cost effective (cheap) and simple emergency light circuit developed for CircuitsToday – This is an automatic emergency lamp with day light sensing, means it senses darkness/night and turns ON automatically. Similarly it senses day light and turns OFF automatically.
A simple emergency lamp which does not require any special equipment; even a multimeter to assemble and use. Any individual who can do a good quality soldering must be able to build this circuit successfully. This can be easily accommodated in the defunct two 6 watt tube National Emergency Lamp or any PL tube type emergency lamp. The difference will be in the working; it will work non stop for more than 8 hours. Deep discharge is taken care by the LED characteristic and over charge protection is taken care by the fixed voltage regulator.This uses a simple 3Pin fixed regulator which has a built in current limiting circuit. The only required adjustment is the preset which has to be set to ensure the LEDs just light up (it should be left at that position). The 5mm LDR is just mounted on top of the emergency light as shown in the photograph. LDR is used to avoid it lighting up during day time or when the room lights are ON. 2 LEDs are used in series; the dropping resistance is avoided and 2 LEDs light up with current that is required for a single LED, by which energy is saved to a great extent.
Note: This circuit is developed by Mr.Seetharaman for readers of CircuitsToday. This particular circuit has been kept so simple for people who has limited access to components or in other words this is an emergency light that you can build with minimum components. In addition to circuit diagram, He has shared photographs of the prototype he made in National emergency light and a PCB design.
Simple Emergency Light Circuit Diagram:
Photographs of prototype made in National Emergency Light:
Emergency Light Circuit PCB Design:
NOTE: Considering the doubts raised by many of our valuable readers in our Comments section, this circuit has been modified by Mr.Seetharaman, one of our valuable contributors. You can see his modified circuit here: Automatic LED Emergency Light Modified.
This is the circuit diagram of a low cost emergency light based on white LED.The white LED provide very bright light which turns on when the mains supply is not there.The circuit has an automatic charger which stops charging when the battery is fully charged.
The IC LM 317 produces a regulated 7 V for the charging of Battery.Transistor BD 140 drives the out put.Transistor BC 548 and Zener diode controls the charging of the battery.
It is always better to connect a heat sink with BD 140.Before using the circuit out put of LM317 must be set to 7V by adjusting the potentiometer.
Automatic LED Emergency Circuit Diagram:
We have more interesting Lighting circuits for you,please take a look:
1. LED Ramping Circuit – An interesting LED application with help of a ramping circuit.
2. Flashing LED Unit – A circuit application to flash many LED’s.
3. Puff to OFF LED circuit – A simple,hobby and more of a fun circuit where you can turn OFF an LED with a puff.
4. Street Light Circuit – Want to build a street light application? This is the one you are looking for.
5. Light Activated Switch – A circuit application to make a switch activated when light falls upon (and vice versa).
If you are interested in knowing How an LED works ? Take a look at our article:- How an LED Works