Missing pulse detector circuit using NE555

jacky July 25, 2011 4 Comments

Description.

An NE555 timer IC connected as shown here can detect a missing pulse or abnormally long period between two consecutive pulses in a train of pulses. Such circuits can be used to detect the intermittent firing of the spark plug of an automobile or to monitor the heart beat of a sick patient.

The signal from the pick up transducer is shaped to form a negative going pulse and is applied to pin 2 of the IC which is connected as a mono stable. As long as the spacing between the pulse is less than the timing interval,the timing cycle is continuously reset by the input pulses and the capacitor is discharged via T1. A decrease in pulse frequency or a missing pulse permits completion of time interval which causes a change in the output level.

Circuit diagram with Parts list.

missing-pulse-detector-circuit.JPG

 

Notes.

  • Assemble the circuit on a good quality PCB or common board.
  • The circuit can be powered  from a 9V battery or 9V DC power supply.
  • The IC1 NE555 could be mounted on a holder.
Comments
  • September 5, 2013

    Nice post thank you vert mych admin …. Sesso

  • devang
    October 14, 2010

    wats da value of r1?????
    n how to generate negative trigger pulse from square!!!!!

  • August 2, 2010

    I hear it’s pretty good, I also intend to use it

  • June 9, 2009

    i am an r&D person so due upate

Leave a Reply to devang Cancel reply

Your email address will not be published. Required fields are marked *