Burglar alarm circuit

Simple Burglar Alarm Circuit


Here is a simple but effective burglar alarm circuit that can be fixed on windows to detect break through. The circuit uses a fine wire element fixed as a network through the window  glass  for sensing the break through . Normally the base of Q1 is held to ground potential by the wire element.So Q1 will be off and SCR H1 will not be conducting,and horn will be off.When the  wire element is broken the base of Q1 will be raised to positive potential, Q1 will be on and so SCR H1 (TYN 612) will be ON making the horn to blow and this condition will be latched by the SCR.The circuit remains ON until the normal condition is restored or the power supply is switched OFF.

Burglar Alarm Circuit Diagram with Parts List .

Burglar Alarm Circuit Schematic

Burglar Alarm Circuit Diagram

Notes .

  • To make the window foil make a loop of very fine wire through the window glass ( two or three lines running in both direction is enough).See figure.Connect the two  free ends of the wires to point A & B as shown in circuit diagram.
  • To setup the circuit , make S1 open and adjust R2 to get a 1V between base of Q1 and ground.(0.7 V is enough to ON Q1).Now transistor will be ON and horn will be blowing.
  • Now ,close S1 and reset the power supply .The transistor Q1 will be  off and horn will not be blowing. The circuit is ready.

Making the window foil .

Window Foil Burglar Anti Theft Alarm

Window Foil Arrangement

We have more Safety Circuits that you may be interested in; Take a look:

1. Metal Detector

2. Intruder Alarm

3. Shock Alarm Circuit

4. Night Security Light

5. Infra Red Barrier

Show Comments

2 thoughts on “Burglar alarm circuit

Leave a Reply

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <s> <strike> <strong>